SMSCOM Twincontroller MK2 4.5A EU
SMSCOM Twincontroller MK2 4.5A EU
The
SMSCOM Twin Controller MK2 is a compact, yet full-featured fan speed controller
for two ventilation fans in total up to 4.5 Amps. The Twin Controller can be
easily set with only three knobs (desired temperature, minimum speed and
maximum speed).
The
SMSCOM Twin Controller MK2 is electronically controlled and offers a simple and
easy way to control the temperature accurately in your grow room. The SMSCOM
Twin Controller MK2 continuously regulates the correct speed of your fans and
maintanes the right temperature. The Twin Controller MK2 has dedicated
poweroutlets for the IN and OUT fan.
Features:
- Accurate
software controlled transformer climate controller
- Simple
operation through three knobs (required temperature, minimum fan speed, maximum
fanspeed)
- Maximum
load up to 4.5A / 1000 watts
- 5 Meter
NTC temperature sensor included
- Replacement
fuse included
- Software-controlled
- 5 year
warranty.
Usage:
- Connect
your fans IN and or OUT fans in the right order to the blue sockets
- Set the
Minimum desired fan speed with knob 1 (e.g. 30%)
- Set the
desired temperature using knob 2 (e.g. 25°C)
- Set the
desired Maximum fan speed with knob 3 (e.g. 90%)
- Place
the temperature sensor in your growroom. Note: not in direct air flow, or
directly under a light source
- Now
plug the Twincontroller MK2 to the mains
The
Twincontroller MK2 can also be used to just controle an extractor fan, to do so
you only have to plug the extractor fan in the "FAN AIR OUT" power
socket. The Twin Controller MK2 will drive the fan and will continuously seek
the best fan speed to maintain the desired temperature.
When
connecting the Twincontroller to the mains, it will start in a scanning mode.
During this 5 minute periode it speed up and slow down attempting to find the
perfect speed for the fans. After the scan process, the Twincontroller will
always know the perfect speed to drive the fans for a constant temperature.
Note: Too slowly rotating fans can create a lot of noice and can also caus failure of the fans. So make sure that the minimum level is not set too low.