SMSCOM SPC 16A MK2
SMSCOM SPC 16A MK2
The
SMSCOM SPC 16A MK2 is the successor to the well-known SPC 14A. The SPC MK2 is
an automatic climate controller for controlling fans. The SMSCOM SPC 16 Ampère
is electronically controlled and provides a simple but accurate way to
automaticly maintain desired room temperature.
The
SMSCOM SPC MK2 16 Ampère controls the correct speed of your fans and maintains
the right temperature. In and / or exhaust fans can be plugged into one of the
two sockets.
The
renewed SPC has an additional connection allowing the SPC 16A MK2 to be easily
expanded with the also newly introduced SPC SLAVE 16A MK2. On each SPC MK2
controller you can connect up to 5 SPC SLAVE 16A units.
Characteristics
- Plug
& Play thanks to its clear layout and easy operation
- 2
different modes Automatic or 100% (Full speed)
- Accurate
temperature controlled speed control
- 5 meter
long temperature sensor
- Adjustable
minimum speed from 20% to 60%
- Maximum
speed adjustable from 60% to 100%
- Desired
temperature adjustable between 10°C and 45°C
- Temperature
bandwidth can be set between 2°C and 7°C.
Operating Instructions
Automatic
temperature control
- Insert
the fan (s) into one of the two sockets, regardless of whether an inflator or
suction motor or even multiple motors are inserted as long as the total maximum
power is not exceeded
- Set the
desired minimum speed with the left-hand dial, for example 30%
- Set the
desired maximum speed with the center dial, for example 80%
- Set the
desired bandwidth with, for example, 3 ° C with the right-hand dial.
- With
the top dial, set the desired temperature in, for example, 25 ° C
- Insert
the SPC MK2 into the socket and turn the switch to "AUTO", the SPC
MK2 will start 100% for a few seconds and then switch to the desired program.
Manual
full power:
- Insert
the SPC MK2 into the socket and turn the switch to "100%".
Specifications
- Model:
00-1010-EU
- Capacity:
Maximum 16 Amps
- Voltage:
220 ~ 240 volts
- Frequency:
50/60 Hz
- Dynamic
Range: 0.5 / 16 Ampere
- Temperature
sensor: 4K7 to 25°C
- Bandwidth:
1 ~ 7°C.
Attention
The SMSCOM SPC MK2 is tuned to the most common fans. However, resetting the minimum speed is possible. To do this, turn the calibration gauge located to the left of the fuse holder behind the cover to the left (min) or right (plus). You adjust the fan so that the fan always rotates to the minimum position. Adjusting the potmeter too low increases the likelihood of an irregular loop that may cause fan motor braking.